@

Wednesday, June 15, 2011

How to remove hood on Toyota Camry?

REMOVAL & INSTALLATION



See Figures 1, 2, 3, 4 and 5

  1. Open the hood completely.
  2. Protect the cowl panel and hood from scratches during this operation. Apply protection tape or cover body surfaces before starting work.
  3. Scribe a mark showing the location of each hinge on the hood to aid in alignment during installation.



Click image to see an enlarged view

Fig. Fig. 1: Scribe marks on the hood where the hinge mates the area

  1. Disconnect any windshield washer hoses.



Click image to see an enlarged view

Fig. Fig. 2: Disconnect the windshield washer hose

  1. Prop the hood in the upright position. Disconnect the hood prop cylinder(s) from the hood (if equipped).



Click image to see an enlarged view

Fig. Fig. 3: Remove the clip retaining the upper portion of the hood struts



Click image to see an enlarged view

Fig. Fig. 4: With an assistant holding the hood in place, slide the strut off the hood



Click image to see an enlarged view

Fig. Fig. 5: Have a helper secure the hood, then remove the attaching bolts

  1. Have an assistant help hold the hood while you remove the hood-to-hinge bolts. Use care not to damage hood or vehicle during hood removal.
  2. Lift the hood off of the vehicle.

To install:
  1. Position he hood on hinges and align with the scribe marks.
  2. Install and tighten the mounting bolts with enough torque to hold hood in place.
  3. Install the hood prop cylinders as required.
  4. Close the hood slowly to check for proper alignment. Do not slam the hood closed, alignment is normally required.
  5. Open the hood and adjust so that all clearances are the same and the hood panel is flush with the body.
  6. After all adjustments are complete, tighten hinge mounting bolts to 10 ft. lbs. (14 Nm).

ALIGNMENT



See Figures 6, 7 and 8

Since the centering bolt, which has a chamfered shoulder, is used as the hood hinge and the lock set bolt, the hood and lock can't be adjusted with it on. To adjust properly, remove the hinge centering bolt and substitute a bolt with a washer for the centering bolt.



Click image to see an enlarged view

Fig. Fig. 6: Shouldered centering bolt which is to be removed during hood adjustment

To adjust the hood forward or rearward and left or right directions, adjust the hood by loosening the side hinge bolts and moving the hood to the desired position. Secure the hinge bolts to 10 ft. lbs. (14 Nm).



Click image to see an enlarged view

Fig. Fig. 7: Hood adjustment directions



Click image to see an enlarged view

Fig. Fig. 8: Turn the adjusting cushion in either direction

To adjust the front edge of the hood in a vertical direction, turn the cushions as required.

To adjust the hood lock, remove the clips holding the radiator upper seal to the upper radiator support. Remove the upper seal from the vehicle and adjust the lock by loosening the lock retainer bolts. Tighten the hood lock mounting bolts to 69 inch lbs. (8 Nm) and reinstall the radiator upper seal when adjustment is complete.


-----------

To Order car parts online:--To get heavy discount on car parts .Click this link below:----

http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html

For car error code diagnosis click the link below:---

http://www.automd.com/diagnose/?amdcid=apwldrbrd1

Car no start:--

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html

No comments:

Post a Comment