@

Showing posts with label check engine light. Show all posts
Showing posts with label check engine light. Show all posts

Tuesday, February 21, 2012

OBD Code is cleared but check engine light will not RESET?

In this particular problem,the customer replaced timing belt and still the check engine light is not getting cleared.

Its steady ON,not flashing.

On basis of the problem,the details are as follows.

First of all,check engine light will not clear directly.The car has to be driven for few miles to get the engine light reset.
The computer in the car has still not seen the part replaced.Once the ECM detects the new parts,the engine light will reset or there is any other problem.

This is a two trip detection logic it would take two drive cycles of this malfunction to occur in order the check engine light to reset. There is a possibility that the VVT I actuator could be sticking also causing the correlation timing problem. However this normally is associated by rough idle or loss of power. Provided the check engine light does not start to flash you should be okay to drive. This is of course unless it has jump time. You stated that you had already replaced the timing belt. Provided the water pump or some other component is not starting to fail the timing belt should still be in good condition. Please be advised that this is an interference engine. If the belt becomes too far out of time or breaks you will damage the engine.So drive two cycles and see if the code clears.Otherwise recheck parts replaced again.

This will help.
Thanks.

see below latest help solutions.

Below is the master help link provided to go through belt routing diagram:---
Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html


Diagnostic code P1330 on Kia 2WD Sorento?

http://technoanswers.blogspot.in/2012/02/diagnostic-code-p1330-on-kia-2wd.html

Diagnostic code P0700, P1330, P1121 on KIA?

http://technoanswers.blogspot.in/2012/02/diagnostic-code-p0700-p1330-p1121-on.html

2003 Kia Sorento shows error code P1330?

http://technoanswers.blogspot.in/2012/02/2003-kia-sorento-shows-error-code-p1330.html

OBD code P1330 on 2003 Kia Sorento?

http://technoanswers.blogspot.in/2012/02/obd-code-p1330-on-2003-kia-sorento.html

OBD code P01300 on Toyota RAV4?

http://technoanswers.blogspot.in/2012/02/obd-code-p01300-on-toyota-rav4.html

OBD code P0768?

http://repairhelpcenter.blogspot.com/2012/01/obd-code-p0768.html

Evaporative Emissions System codes details?

http://schematicsdiagram.blogspot.com/2011/11/evaporative-emissions-system-codes.html

           

Engine Misfire codes on Chevrolet Malibu?


Misfire on cylinder 4?

ABS trouble codes for all 1994-00 Acura models?

Diagnostic code P0010?

http://schematicsdiagram.blogspot.com/2011/12/diagnostic-code-p0010.html

Diagnostic Code P1396?


Code P0452?


OBD code P0172 on Buick Park Avenue?


DTC Code P0321 on Buick Park Avenue?

                      

Error Code P0471 on 2007 Dodge Ram 3500?


P0304 Error code on Dodge Neon?


OBDII scan is receiving NO BUS CODE?


How to Clear OBD error Codes on Acura Car Models?


Diagnosis and Testing Car Components?

Diagnostic Trouble Codes list for Acura Car Models?

Part 1.

Diagnostic Trouble Codes list for Acura Car Models?

Part 2.

Monday, December 5, 2011

Heating Knob light bulb under dash replacement for Chevrolet Equinox?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


Its not very hard,the details are as follows :---
Its the tiny/very small  incandescent light bulb/lens.It is behind the knob soldered to the circuit board, you must remove the climate control head unit and take it apart to access the knobs back light bulb on the circuit board. You can buy the replacement bulb at Radio Shack, the part number is 7219 Micro Lamp.
This details will help.Thanks.
-----------------
For more car lights repairs and replacement,check the list below:----

Only high beams work but head lights not working on Ford F350?


Only high beams working on GMC Savana?

High beams stopped working but headlights still work?


Only one head light works on 2001 Dodge Caravan?

http://howtobyme.blogspot.com/2011/11/only-one-head-light-works-on-2001-dodge.html


The Brake Indicator Light Stays On dash of car?

The ABS and Traction Control Lights stays ON dash of car?


Check Engine Light On car?


ABS & Brake warning lights remains steady on dash?

 -------------------------

How to replace Interior Lights on car?

 

Car lights not working, even after replacing the bulb/lamp?

Click this link below:--
 ---------------

 

How to replace head lights on car?

--------------------

How to replace Parking, turn, and Brake Lights on car?

Upper brake lights work, but low brake light not working?

Oldsmobile Alero license plate bulb replacing?

http://schematicsdiagram.blogspot.com/2011/12/oldsmobile-alero-license-plate-bulb.html


Friday, December 2, 2011

Why airbag light flashes 7 times?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


Its a procedure,not a problem.
If the airbag light goes off after that 7 blinks (some are 6 or 8), that will be normal. The airbag module will blink the airbag warning light on the cluster while performing self-test during initial start-ups. After the self-test and the airbag module did not detect any fault within the airbag system, it will turn the warning light off. If the airbag warning light continuously blink or stayed lit after the expected elapse time, then there is really a concern and you need to double check the airbag system with a scan tool.If the Airbag light stays on steay after flashing 7 times,then yes there is error code stored in airbag module,getting the module scanned is advisable.
This basic details will help.Thanks.
--------------------
For more car problems and solutions,go through the list mentioned below:-----

The Brake Indicator Light Stays On dash of car?

The ABS and Traction Control Lights stays ON dash of car?


Check Engine Light On car?


ABS & Brake warning lights remains steady on dash?

 -------------------------

Car jerks while going uphill and Check engine light is ON?


Car turns over, but only starts, if starter is jumped?


Service Engine Soon light stays on?


Gasoline around gas cap?


Car will not run after resetting inertia switch on Mercury Mystique?

VAN emits whitish bluish smoke and bad fuel smell from exhaust

Car cigarette lighter fuse blows out?

CD MECH ERROR?

Car will not go into 4WD high or 4WD low?

Truck is hard to start and Emits smoke while starting?

Engine cuts out at 3000 RPM?

Car turns over but will not start, only makes clicking sound?

Catalytic Converter glowing hot?

After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?


Fuel gauge jumps from empty to full?

http://schematicsdiagram.blogspot.com/2011/12/fuel-gauge-jumps-from-empty-to-full.html


Thursday, December 1, 2011

Service Engine Soon light stays on?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


Very known problem,many car users notice this same problem.
Basically,your vehicle computer module has stored an error code,first you have to get computer scanned.That will let to get the code.

The light is on to alert you to the fact that a fault has occurred in the engine management system(s) or a part of the emission control system, there are over a 100 different problems that turn this light on, take the car to any Kragen auto parts,Auto Zone, Shukes etc and they will test the system for free, it could be as simple as a loose or defective gas cap seal, etc etc.
Without exact code,there are hundreds of parts to be inspected.
Getting scanned is the best possible option to confirm the fault in minutes.
-----------
For more help,check the list mentioned below:----

The Brake Indicator Light Stays On dash of car?

The ABS and Traction Control Lights stays ON dash of car?


Check Engine Light On car?

 -------------------------

How to replace Interior Lights on car?

 

Car lights not working, even after replacing the bulb/lamp?

Click this link below:--
 ---------------

 

How to replace head lights on car?

--------------------

 

How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html

Vehicle smog test failed Due to NO MIL/check engine light?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


This happens very rarely,smog test failure is very common problem,but due to no check engine light coming ON,is very rare.
Basically, it means the check engine warning light didn't light up when it should. Perhaps a burned out bulb?
Every vehicle has a "system check" that happens every time you turn the key on. Most people don't know it is happening right before thier eyes. So if you go out and get into your car in the morning and you turn the key to "on" but then don't go the rest of the way to the "start" position there are several warning lights on. The check engine light is one of them. All the system is doing is running power through the light to show it is functional.
It doesn't mean there is something wrong, it is just showing that an error "can" be displayed if an error existed by the light being on. Try it next time. Turn the key on but dont start the engine. If your check engine light is off, then that is what they stated in the report.
This basic details will help.
Thanks.
---------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


The Brake Indicator Light Stays On dash of car?

The ABS and Traction Control Lights stays ON dash of car?


Check Engine Light On car?

 -------------------------

How to replace Interior Lights on car?

 

Car lights not working, even after replacing the bulb/lamp?

Click this link below:--
 ---------------

 

How to replace head lights on car?

--------------------

 

How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html


Car jerks while going uphill and Check engine light is ON?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

This problems needs to be scanned to confirm.
It sounds like a sensor is intermittantly loosing the data stream. Since the engine light came on, I would go to a reputable shop and have them check for codes. Many auto parts stores will do this as well and sometimes for free. Can't beet free. If I were to guess I would say something like the camshaft postion sensor is going bad, Or the crankshaft postion sensor, Or something like that. The code will tell which one it is.
This will help.
Thanks.
---------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------