How to Replace a Battery?

Open the hood and locate your battery.

Check the battery voltage with a digital multimeter. If the battery voltage is less than 12 volts, charge the battery and perform a load test. Performing a load test will confirm if the battery is good or bad.

First, remove the negative battery cable from the battery. Wrap the cable end in a towel and set it away from the battery.
Photo may not be specific to your vehicle

Next, remove the positive battery cable from the battery.
Photo may not be specific to your vehicle

Remove the battery hold-down or clamp.
Photo may not be specific to your vehicle

Note which direction the battery terminals are facing. Remove the battery from the battery tray.
Photo may not be specific to your vehicle

Clean the battery tray and hold-down with water.

Place the new battery into the battery tray with the terminals on the proper side. Re-install the hold-down or clamp.

Clean the battery cable ends (connectors) and the battery posts with a wire brush.

First, place the positive cable end on the positive battery post. Tighten the cable bolt.

Next, place the negative cable end on the negative battery post. Tighten the cable bolt.

After the new battery is installed, start the engine and check the charging system with a digital multimeter. The battery voltage should read between 13.5 to 14.5 volts.
Photo may not be specific to your vehicle

To Order car parts online:--To get heavy discount on car parts .Click this link below:----

http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html

For car error code diagnosis click the link below:---

http://www.automd.com/diagnose/?amdcid=apwldrbrd1

Car no start:--

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html