@

Thursday, December 15, 2011

How to replace Intake Manifold on 2008 Honda Odyssey?

Replace Intake Manifold on Honda vehicle is as follows :-----------

Intake Manifold

Removal & Installation



  1. Remove the intake manifold cover.
  2. Remove the air inlet duct.
  3. Remove the PCV hose and brake booster hose.
  4. Remove the EVAP canister hose and water bypass hoses. Plug the bypass hose.
  5. Tag and disconnect all wiring connected to the manifold.
  6. Remove the upper cover mounting bolts and nuts, in 2 equal steps, in the sequence shown. Remove the cover.

    Click image to see an enlarged view
    Fig. Upper cover loosening sequence-J35A6 and J35A7 engines
  7. Remove the intake manifold mounting bolts and nuts, in 2 equal steps, in the sequence shown. Remove the manifold.

    Click image to see an enlarged view
    Fig. Intake manifold loosening sequence-J35A6 and J35A7 engines
  8. Installation is the reverse of removal. Tighten the manifold bolts and nuts, in the sequence shown, in 2 equal steps, to 16 ft. lbs. (22 Nm). Tighten the cover bolts and nuts, in the sequence shown, in 2 equal steps, to 105 inch lbs. (12 Nm).

    Click image to see an enlarged view
    Fig. Intake manifold torque sequence-J35A6 and J35A7 engines


    Click image to see an enlarged view
    Fig. Upper cover torque sequence-J35A6 and J35A7 engines


    Click image to see an enlarged view
    Fig. Intake manifold and related parts-J35A6 engine


    Click image to see an enlarged view
    Fig. Intake manifold and related parts-J35A7 engine

-----------
This details will help you.
----------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

--------------

No comments:

Post a Comment