Why airbag light flashes 7 times?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


Its a procedure,not a problem.
If the airbag light goes off after that 7 blinks (some are 6 or 8), that will be normal. The airbag module will blink the airbag warning light on the cluster while performing self-test during initial start-ups. After the self-test and the airbag module did not detect any fault within the airbag system, it will turn the warning light off. If the airbag warning light continuously blink or stayed lit after the expected elapse time, then there is really a concern and you need to double check the airbag system with a scan tool.If the Airbag light stays on steay after flashing 7 times,then yes there is error code stored in airbag module,getting the module scanned is advisable.
This basic details will help.Thanks.

--------------------

For more car problems and solutions,go through the list mentioned below:-----

The Brake Indicator Light Stays On dash of car?

http://schematicsdiagram.blogspot.com/2011/06/brake-indicator-light-stays-on-dash-of.html

The ABS and Traction Control Lights stays ON dash of car?

http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html

Check Engine Light On car?

http://schematicsdiagram.blogspot.com/2011/06/check-engine-light-on-car.html

ABS & Brake warning lights remains steady on dash?

http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html

 -------------------------

Car jerks while going uphill and Check engine light is ON?

http://schematicsdiagram.blogspot.com/2011/12/car-jerks-while-going-uphill-and-check.html

Car turns over, but only starts, if starter is jumped?

http://schematicsdiagram.blogspot.com/2011/12/car-turns-overbut-only-startsif-starter.html

Service Engine Soon light stays on?

http://schematicsdiagram.blogspot.com/2011/12/service-engine-soon-light-stays-on.html

Gasoline around gas cap?

http://schematicsdiagram.blogspot.com/2011/12/gasoline-around-gas-cap.html

Car will not run after resetting inertia switch on Mercury Mystique?

http://schematicsdiagram.blogspot.com/2011/12/car-will-not-run-after-resetting.html

VAN emits whitish bluish smoke and bad fuel smell from exhaust

http://schematicsdiagram.blogspot.com/2011/12/van-emits-whitish-bluish-smoke-and-bad.html

Car cigarette lighter fuse blows out?

http://schematicsdiagram.blogspot.com/2011/12/car-cigarette-lighter-fuse-blows-out.html

CD MECH ERROR?

http://schematicsdiagram.blogspot.com/2011/12/cd-mech-error.html

Car will not go into 4WD high or 4WD low?

http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

Truck is hard to start and Emits smoke while starting?

http://schematicsdiagram.blogspot.com/2011/12/truck-is-hard-to-start-and-emits-smoke.html

Engine cuts out at 3000 RPM?

http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

Car turns over but will not start, only makes clicking sound?

http://schematicsdiagram.blogspot.com/2011/12/car-turns-over-but-will-not-startonly.html

Catalytic Converter glowing hot?

http://schematicsdiagram.blogspot.com/2011/12/catalytic-converter-glowing-hot.html

After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?

http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html

Fuel gauge jumps from empty to full?

http://schematicsdiagram.blogspot.com/2011/12/fuel-gauge-jumps-from-empty-to-full.html