In this case the vehicle is 2000 ford expedition.
The customer is hearing/getting loud humming vibrating noise.The noise is even noticed with engine turns off.
The problem is strange,but this problem is very much noticed on ford vehicles.Many other ford vehicle owners notice this problem too.
On that basis the troubleshooting of the problem is as follows :-----
You have described one of 2 possible components causing this being a ABS ECU which has failed and is causing the ABS motor to continually run or a concern with the Air suspension compressor if its equipped with air suspension instead of springs.
But if there is no air suspension on your ford then,This would mean its most likely the ABS motor. Try removeing fuse 102 under the hood.
For location of the correct fuse,locate the fuse box under hood.
For its location see the fuse location diagram below :-----
The fuse number 102 is very last fuse in the fuse box.
For its exact location,see the diagram shown below.Its marked with yellow color:-----
This will help.
Thanks.
See below latest solved car problems :-----
How to replace Drive Shaft bearing on
http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-drive-shaft-bearing-on.html
Car suddenly died and won’t start?
http://technoanswers.blogspot.in/2012/02/car-suddenly-died-and-wont-start.html
Car is starting but not turning over?
http://technoanswers.blogspot.in/2012/02/car-is-starting-but-not-turning-over.html
Engine cranks but will not start?
http://technoanswers.blogspot.in/2012/02/engine-cranks-but-will-not-start.html
Exclamation indicator light on ford freestar dash?
http://technoanswers.blogspot.in/2012/02/exclamation-indicator-light-on-ford.html
2004 ford freestar van idles rough?
How to remove Intake Manifold Tuning Valve?
http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html
Trunk release Problem on Toyota Camry?
http://schematicsdiagram.blogspot.in/2012/02/trunk-release-problem-on-toyota-camry.html
CMFI details for GMC vehicles?
http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html
Mazda MPV cranks but will not start?
MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?
http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html
Freightliner fl112 fuse box diagram?
http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html
Car will not turn the ignition to start?
http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html
Car only starts when gas pedal is pressed?
http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
How to compare pattern of left bank and right bank sensors?
http://schematicsdiagram.blogspot.in/2012/02/how-to-compare-pattern-of-left-bank-and.html
Check power train warning light on?
Check power-train message with orange engine light came on?
Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?
http://howtobyme.blogspot.in/2012/02/check-powertrain-message-and-safety.html
Hyundai coupe f2 hazard fault?
http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html
Where is the pcv valve located on 2007 Duratec ford focus xr5?
http://repairhelpcenter.blogspot.in/2012/02/where-is-pcv-valve-located-on-2007.html
Gas door hinges broken on
http://technoanswers.blogspot.in/2012/02/gas-door-hinges-broken-on-toyota.html
From where to buy new flow valve for Citroen 16 BX?
http://schematicsdiagram.blogspot.in/2012/02/from-where-to-buy-new-flow-valve-for.html
Where is the bulb located in glove box?
http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012
http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html
The customer is hearing/getting loud humming vibrating noise.The noise is even noticed with engine turns off.
The problem is strange,but this problem is very much noticed on ford vehicles.Many other ford vehicle owners notice this problem too.
On that basis the troubleshooting of the problem is as follows :-----
You have described one of 2 possible components causing this being a ABS ECU which has failed and is causing the ABS motor to continually run or a concern with the Air suspension compressor if its equipped with air suspension instead of springs.
But if there is no air suspension on your ford then,This would mean its most likely the ABS motor. Try removeing fuse 102 under the hood.
For location of the correct fuse,locate the fuse box under hood.
For its location see the fuse location diagram below :-----
The fuse number 102 is very last fuse in the fuse box.
For its exact location,see the diagram shown below.Its marked with yellow color:-----
This will help.
Thanks.
See below latest solved car problems :-----
No comments:
Post a Comment