On this 2003 Ford explorer vehicle the IAT , intake air temp sensor ,,has been made into the MAF, the mass air flow sensor.
And its is the component right after the air filter.
See the diagram shown below :----
The MAF /IAT assembly is number 6 in the pic above:--
The two wires for the IAT , located inside the MAF are the GRAY wire and the GRAY/RED wire.
This will help.
Thanks.
See below latest solved car problems :---
How to replace Drive Shaft bearing on Toyota pick up?
Car suddenly died and won’t start?
Car is starting but not turning over?
Engine cranks but will not start?
Exclamation indicator light on ford freestar dash?
2004 ford freestar van idles rough?
How to remove Intake Manifold Tuning Valve?
Trunk release Problem on Toyota Camry?
CMFI details for GMC vehicles?
Mazda MPV cranks but will not start?
MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?
Freightliner fl112 fuse box diagram?
Car will not turn the ignition to start?
Car only starts when gas pedal is pressed?
How to compare pattern of left bank and right bank sensors?
Check power train warning light on?
Check power-train message with orange engine light came on?
Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?
Hyundai coupe f2 hazard fault?
Where is the pcv valve located on 2007 Duratec ford focus xr5?
Gas door hinges broken on Toyota?
From where to buy new flow valve for Citroen 16 BX?
Where is the bulb located in glove box?
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?
Noise coming from the driver side under the air intake filter?
Fail smog test due to gas filter hose?
Clutch squeaking under hood?
How to open Stuck up bonnet on Volvo s40?
WHERE IS THE PAINT CODE IDENTIFICATION NUMBER located on BUICK cars?
How to remove Rear Adjustable Arm on 2007 Toyota Camry?
Engine stalls when gas is given?
4x4 front differential will not engage the axle on ford?
No comments:
Post a Comment