@

Saturday, May 28, 2011

How to Bleed Brakes?

Park your vehicle on a solid level surface and set the parking brake.Open the hood and locate the brake master cylinder reservoir.
6962Photo may not be specific to your vehicle

Siphon the old brake fluid from the master cylinder reservoir with a turkey baster. Refill the reservoir with clean brake fluid that meets OE specifications (DOT 3 or DOT 4).Using a floor jack, lift up the front of your vehicle and support it with jack stands. Then lift up the rear of your vehicle and support it with jack stands.
6840Photo may not be specific to your vehicle

Place a 1 x 4 block of wood under the brake pedal to prevent the pedal from traveling too far.Locate the brake bleeder valve behind the right rear wheel. The bleeder valve is attached to the brake wheel cylinder or the brake caliper.Install a piece of clear plastic tubing over the brake bleeder valve and insert the other end into a clear container, filled with 2 to 3 inches of clean brake fluid.
6318Photo may not be specific to your vehicle

Have your assistant pump the brake pedal several times and then hold it down.Slowly open the bleeder valve. After the old fluid and air bubbles stop flowing, tighten the bleeder valve and then have your assistant slowly release the pedal.
6316Photo may not be specific to your vehicle

Repeat this process until clean fluid comes out of the bleeder valve and there are no more air bubbles.

Check and refill the master cylinder. Do not allow the master cylinder to drain completely.Repeat the bleeding process for the rest of the wheels in the following order: Left rear wheel, right front wheel, left front wheel.Verify that the master cylinder reservoir is full and you have a solid brake pedal. Lower the vehicle to the ground and perform a road test.

No comments:

Post a Comment