Ignition Control Module (ICM) REMOVAL and INSTALLATION?

REMOVAL & INSTALLATION

See Figures 1, 2 and 3

Only the EEC-IV ignition systems use an external ICM. EEC-V systems have incorperated the ICM into the Power Control Module (PCM).

1. Disconnect the negative battery cable.
2. Detach the wiring harness connector(s) from the ICM.
3. Remove the mounting bolts, then remove the ICM.

To install:

4. Position the ICM onto the inner fender apron and install the mounting bolts. Tighten the bolts to 22-31 inch lbs (2.5-3.5 Nm).
5. Attach the wiring harness connector(s) to the ICM.
6. Connect the negative battery cable.

Fig. Fig. 1: Ignition control module and mounting location on the 2.3L, 2.5L engine

Fig. Fig. 2: Ignition control module used on all EEC-IV systems except the 2.3L engine

Fig. Fig. 3: Ignition control module mounting on all EEC-IV systems except the 2.3L engine

To Order car parts online:--To get heavy discount on car parts .Click this link below:----

http://technoanswers.blogspot.com/2011/05/from-where-to-order-car-parts-online.html

For car error code diagnosis click the link below:---

http://www.automd.com/diagnose/?amdcid=apwldrbrd1

Car no start:--

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html