Friday, March 16, 2012

How To Replace Blower Motor On Ford Ranger?

The Blower Motor Replacing details are as follows:----

Blower Motor Removal & Installation Procedure is Shown below:---

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the speed control actuator electrical connector.
  3. Remove the speed control actuator bolt and position the speed control actuator aside.
  4. Disconnect the blower motor wire harness connector.
  5. Remove the blower motor vent tube.
  6. Remove the 4 blower motor screws and the blower motor.
  7. Remove the blower motor wheel clip.
  8. Remove the blower motor wheel.
  9. To install, reverse the removal procedure and tighten the speed control actuator bolt to 97 inch lbs. (11 Nm). 

    Fig. Blower motor-exploded view
These details will help.


Car repair guide?

No comments:

Post a Comment