@

Tuesday, February 21, 2012

Where is Crankshaft position sensor located on Toyota Tundra?

The crankshaft position sensor is located on the bottom left corner of the front aluminum housing for the oil pump. It is just above and near the oil filter housing assembly. Is a two pin sensor with one connector. 
Check both the sensor pin and its connector.If it gets dirty,loose then cleaning it helps.But if its worn out or cracked then replace it.


This will help.
Thanks.


See below latest solved car problems :----


Hyundai coupe f2 hazard fault?

http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html

Gas door hinges broken on Toyota?

http://technoanswers.blogspot.in/2012/02/gas-door-hinges-broken-on-toyota.html

Where is the bulb located in glove box?

http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html

Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?

http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html

Fail smog test due to gas filter hose?

http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html

Clutch squeaking under hood?

http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html

Engine stalls when gas is given?

http://technoanswers.blogspot.in/2012/01/engine-stalls-when-gas-is-given.html

4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

1990 mazda 323 stalls and quit running?

http://technoanswers.blogspot.in/2012/02/1990-mazda-323-stalls-and-quit-running.html

No comments:

Post a Comment