Thursday, June 7, 2012

1996 Jeep Grand Cherokee: Procedure to replace Blower Motor Resistor?

How to replace Blower motor resistor.

Many car owners with less knowledge about car repairs and parts replacement.Remove complete glove box to replace blower motor resistor.

BUT actually,There is no need to remove the glove box to access the resistor. If equipped, you only need to remove the insulator panel (the panel right above where the passenger's feet would be). There are a few small screws around the perimeter holding this panel in place. From there, you should have a clear shot.

See the help diagram shown below:--------

blower motor and resistor

Just follow this simple process:----

-Disconnect the negative cable from the battery.
-Remove the blower motor resistor connector(s).
-Remove the resistor retaining screws.
-Remove the blower motor resistor.

This details will help.

Users Who Viewed This Problem Also Viewed:

Where is Blower motor resistor located on 2006 Ford F 250?


How to replace Blower motor resistor on 2001 Mazda Protege?


Mazda Protege Blower motor wiring diagram?


Mazda blower motor only works on high mode?


Blower motor Resistor shorting problem?


How to replace blower motor and blower motor resistor on Pontiac G6?


For All types of Car models and brands help 
Go to Newly Launched

FREE Car repair guide? 

Complete Car repair Help FREE? 

No comments:

Post a Comment