Thursday, December 15, 2011

How to replace Oil Pressure Sensor on 2008 Honda Odyssey?

Oil Pressure Sensor replacing details are as follows :----

Removal & Installation

Specific to:
Honda Odyssey 2007-2008
  1. Disconnect the oil pressure switch wiring harness.
  2. Remove the oil pressure switch.
To install:
  1. Installation is the reverse order of removal.
  2. 2008 J35A6 Engines: Install the switch with a new O-ring.


Specific to:
Honda Odyssey 2007-2008
  1. Remove the oil pressure switch, then install an oil pressure gauge.
  2. Start the engine. Shut it off immediately if the gauge registers no oil pressure. Repair the problem before continuing.
  3. Allow the engine to reach operating temperature (fan comes on at least twice).
  4. If oil pressure is not within specifications, inspect these items:

    Blocking of oil filter
    Blocking of oil screen
    Inspect the oil pressure relief valve
    Inspect the oil pump

This details will help you.
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

For your help, there are few Car Engine oil related solved problem listed below. You can go through it.

Low oil pressure light on Dodge Magnum? 

Kia Sportage leaking oil from oil pan? 
Car Turns OFF due to low oil pressure warning light?

For more oil and oil pump details check out the direct links below: --- 
Oil pressure for 2001 gmc jimmy V6? 

How to replace Oil Pan on 2008 Honda Odyssey?


1 comment:

  1. It's always interesting to read through articles from other writers and use a little something from other websites.
    Fomblin Y VAC 3