Front and Rear Halfshafts Replacing for Toyota car models?

The details mentioned below are for both Toyota Land Cruiser and Toyota Sequoia car models.


Halfshafts
REMOVAL & INSTALLATION Step by step instructions with diagrams is as follows :---

1. Remove or disconnect the following: 
   
   
   Front wheel

   Brake caliper

   Grease cap

   Snapring

   Wheel speed sensor and wire harness

   Steering knuckle arm

   Lower ball joint

   Upper ball joint

   Steering knuckle

   Axle halfshaft 
   
    
   

   Fig. Halfshaft and related components-Land Cruiser

   
   
   
   

   Fig. Axle halfshaft removal-Land Cruiser

To install:

NOTE

Use new split pins, snaprings and circlips for assembly.

1. Install or connect the following:
   
   
   Axle halfshaft

   Steering knuckle

   Upper ball joint. Tighten the nut to 81 ft. lbs. (110 Nm).

   Lower ball joint. Tighten the nut to 117 ft. lbs. (159 Nm).

   Steering knuckle arm. Tighten the bolts to 108 ft. lbs. (147 Nm).

   Wheel speed sensor and wire harness

   Snapring

   Grease cap

   Brake caliper

   Front wheel

1. Before servicing the vehicle, refer to the Precautions section.
2. Remove or disconnect the following:
   
   
   Front wheel

   Under cover
3. Drain the differential oil.
4. Remove or disconnect the following: 
   
   
   Grease cap

   Cotter pin and lock cap

   Halfshaft locknut by applying the brakes

   Lower control arm from the lower ball joint

   Halfshaft from the steering knuckle, using a plastic hammer

   Left strut, for the left halfshaft

   Right halfshaft, using a brass bar and a hammer

   Left halfshaft, using tools 09520-01010 and 09520-24010

   Snapring from the inboard joint shaft 
    

   Fig. View of the halfshaft and related components-Sequoia

To install:

1. Install or connect the following:
   
   WARNING

   Be careful not to damage the oil seal, boot or dust seal.
   
   
   
   
   New snapring, onto the inboard joint shaft with the opening facing downward

   Halfshafts to the differential using a brass bar and a hammer

   Halfshafts to the steering knuckles
   
   
   
   
   Lower control arm to the lower ball joint using a new cotter pin. Torque the ball joint nut to 103 ft. lbs. (140 Nm).

   Halfshaft locknut by applying the brakes. Torque the nut to 173 ft. lbs. (235 Nm).

   Lock cap and a new cotter pin

   Grease cap
2. Refill the differential with oil.
3. Install or connect the following:
   
   
   Under cover

   Front wheel

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html